The easiest way to remove 3D prints stuck on your 3D print bed is to heat up the bed temperature to 70°C then use a good quality scraper to get under the print and lift it off. You can use liquid solutions to weaken the bond between the print bed and the plastic to help remove 3D prints.

What is the easiest way to remove a 3d print from a glass bed?

Run cool tap water on the back side of the plate to cool quickly. The print material will contract more than with normal cool down. Once cool, the print can be popped off. If glue was used on the glass plate, run lukewarm water over the print side of the plate to dissolve the glue.

Should you remove filament after printing?

Some filaments need storing away from moisture because they tend to absorb moisture. It results in them not printing well due to the high heat that the filament has to go through. The filament might become a bit brittle but overall it is not very risky to leave it out there.