POWER UP
Insert 2-AA batteries into your Outdoor Sensor.Insert 2-AA batteries into your Clock.Adjust time and date settings on your Clock.Once the Outdoor Sensor is reading to your clock, place it outside in a shaded location.
How do you reset an atomic clock?
Press and hold the “REC” button (D) for 3 seconds. The clock will search for the atomic signal. The clockʼs hands will move to the 12:00 position and the atomic signal will be received within 3-12 minutes. Once the atomic signal has been received, the clock will set itself to the correct time.
How do I reset my LaCrosse atomic wall clock?
Hold the WAVE button down for 3+ seconds. The hands will automatically reset to the 12:00 position, and the clock will search for the WWVB time signal. If the clock receives the signal, the clock will set automatically to the correct time.
How do you set an atomic clock manually?
Atomic Clocks may also be set manually and be very accurate. Simply insert the battery, press your time zone and then press the flap just above the left side of the battery. Hold until you reach the correct time and then release. Your clock is now an accurate quartz clock until it will find the signal.
Why is my atomic clock not working?
Try powering down the clock (unplug it or remove the batteries), then turn it on again to see if it synchronizes. If the clock uses batteries, check them and replace if necessary. If the radio controlled clock is a desk top unit, try rotating it 90 degrees.
How long does it take for an atomic clock to reset?
When you turn a radio controlled clock on, it will probably miss the first time code, so it usually takes more than one minute to set itself (sometimes 5 minutes or longer) depending on the signal quality and the receiver design.
How does an atomic clock set itself?
Atomic Time & Date
Atomic clocks automatically synchronize to a radio signal called WWVB that the National Institute of Standards and Technology (NIST) broadcasts continuously from Fort Collins, Colorado. This signal transmits the official time from the Atomic Clock in Boulder, Colorado.
Why does my radio controlled clock show the wrong time?
Try rotating the clock. Most radio-controlled clocks have an internal antenna that picks up the signal most effectively when it is facing directly towards or away from Anthorn. Some clocks have a signal strength indication that helps in finding the best reception. Try moving your clock to a different location.
What is Wave button on atomic clock?
Wave clocks earn their title for the radio waves that accurately set their time. Long-range 60 kHz radio signals sent from the U.S. National Institute of Standards and Technology (NIST) radio station, WWVB, reach the radio receiver inside your clock and set the correct time to your time zone.
