The following reset procedure is used when the scale shows an err2, err, 0.0, inaccurate weight, or some other unusual error.
Remove the battery from the scale.Sit the scale on a hard surface floor.Step up onto the scale, stand still for about 5 seconds and step off the scale.Re-install your battery.
How do you set a Taylor Digital Scale?
Stand on the scale for 10 seconds (still without the battery). Carefully replace the battery without pressing any buttons or activating the scale. Set the scale on the floor (no carpet) with the battery in place. Using only one foot, tap the scale or apply just enough pressure to turn on the display.
Why does my Taylor scale show different weights?
Your digital scale may show an error message or an inaccurate reading if the unit is overloaded. Each scale has a maximum weight capacity, so if the user weighs more than the maximum, the scale is unable to provide a weight.
How do you change the units on a Taylor scale?
Instead, press “power”, and then “SET”. Display shows JUST “kg” or “lb”. Press up or down arrow to toggle between Pounds (English units) and Kilograms (metric). Then, tap “SET” 4 times to confirm the other settings for the current user (gender, age and height), and you’re done.
How do I reset my digital scale?
Follow these instructions to reset your scale:
Remove all batteries from the back of your scale.Leave the scale without its batteries for at least 10 minutes.Make sure that the battery compartment is clean, and the contact terminals are free of debris or residue. Place your scale on a flat and completely even surface.
How do you calibrate a scale?
Calibrating Your Scale
Power on the scale and allow it to warm up (usually 30 seconds) Begin the calibration mode sequence. Follow the instructions on the scale’s display. Once the calibration process has been completed, remove the calibration weight and return to normal weighing modes.
How do you use a Taylor kitchen scale?
Place the scale on a hard, level surface. ” (power) button to turn the scale on. The display will show “-18:888” and then zero when it is ready for use. If the display does not show zero, wave your hand within 3 inches over the “TOUCHLESS TARE” symbol on the scale platform to reset the scale to zero.
How do I fix scale error?
Flip the scale over and change new batteries. Make sure the scale doesn’t turn on. Turn on the display using one foot to tap on the scale. Take your feet off and let the scale turn off by itself.
How do you change Taylor scale to grams?
Place the scale on a hard, level surface.Press the “ON/OFF” button to turn the scale on. The display first shows. Your scale is set at the factory to weigh in ounces. To switch to grams, Place the item to be weighed on the center of the platform. The scale will turn off automatically after 1½ minutes of non-use.
How do I reset my digital bathroom scale?
#1 Every time a digital scale is moved it needs to be calibrated.
Place the scale back on a hard, flat surface (see #2 below for optimal flooring surfaces).With one foot, press the platform of the scale so that numbers appear on the display. Wait for the scale to turn off again.Your scale is now calibrated.
How do I change my health meter scale to pounds?
Look on the rear of the Health-o-meter Touch scale. Locate the selector lever to change the scale from kilograms (kgs.) to pounds (lbs.). Place the scale back onto a flat, hard surface.
How do I know if my digital scale is off?
5 Signs You Need to Replace Your Scales
Inconsistent Scale Readings: Inaccurate Readings Between Scales: Unstable Readings: Display Readability: Rust or Other Corrosive Damage:
How do you set a scale to zero?
To zero, or tare, your scale: If your scale does not display zero weight when turned on with nothing placed on it, simply press the ON/OFF button and the scale will reset to zero.
