Put your key in the ignition and turn it to position one, the position just before starting the car. Push and hold the trip meter reset button on the dashboard, then turn your key to position two. Continue holding the odometer button for 10 seconds. The light should then flash, possibly beep, and then go out.
Why is my maintenance required light still on after oil change?
Most often this just means your vehicle might be due for an oil change. The light will come on and remain on if the distance driven exceeds 5,000 miles after the maintenance data has been reset.
How do you reset the maintenance light on a Toyota Tundra?
How to Reset Maint. Required Light on a Toyota Tundra
Turn your key to the “On” notch, and press your trip odometer knob until “Trip A” is displayed.Turn your key to the “Off” notch. Press and hold the trip odometer knob. Wait for the system to reset. Release the trip odometer knob when “Trip A” is displayed again.
How do you reset maintenance light on Toyota Camry?
Quickly push and hold the odometer button on your dashboard, then turn your key to position two. Continue to hold the odometer button for about 10 seconds. The maintenance light should start to flash, and you may hear a beeping sound. Then the light should go out.
How do I reset my car after service?
Step 1 – Start the engine. Step 2 – If a service is due the display will show “Service required”. To reset this message, locate and press the OK button located at the top right of the steering wheel for more than 1 second. Step 3 – The service interval will be reset to the default setting.
How do you reset the dash light after an oil change?
Oil Change Indicator Reset
Switch the ignition on. Fully press the accelerator and brake pedals at the same time.Keep the accelerator and brake pedals fully pressed.After three seconds, a message displays confirming the reset procedure is in progress.
How do you reset the maintenance required light on a 2010 Toyota Camry?
Quickly push and hold the odometer button on your dashboard, then turn your key to position two. Continue to hold the odometer button for about 10 seconds. The maintenance light should start to flash, and you may hear a beeping sound. Then the light should go out.
