Pool cover anchors are used to fasten the straps of winter pool covers to the ground or deck. The anchors are typically brass.

Each Spring and fall some members do the following:
Unscrew the inside anchor from its base.Rinse off all the dirt from the threads and let dry.Then use silicone lube on the threads.

What can I use to hold my pool cover down?

Water bags are the easiest and most effective way to hold down your winter pool cover. Built from heavy-duty vinyl designed to withstand sub-zero temperatures, water bags provide peace of mind. Once installed, you know your pool cover will be secure all winter long.

How do you replace pool anchors in concrete?

Using our Brass Anchor Removal Kit, you can replace your cover pins in just minutes. Drill out the stripped hole with the drill bit, cut threads into the hole with the tap, assemble cylinder, plate, nut and bolt and just simply turn the nut with a wrench to easily raise a broken cover anchor from the concrete.

What size are pool anchors?

Answer: 1-5/8″ long, 13/16″ top diameter, 3/4″ bottom diameter.

Can you walk on a pool safety cover?

A safety cover is a spring loaded, fairly taut cover that is meant to hold the weight of a person if they accidentally walk across it. Its use is primary for the winter but it can be left on when you are on vacation in the middle of the summer, even with the pool running.

How do I stop my pool cover from blowing in the wind?

The best way to prevent large build ups of ice is to keep the water level on top of the pool cover to a minimum. You will want to keep a half inch of water on top of the pool cover to keep it from blowing during heavy winds.

How do you keep an above ground pool cover down?

Above ground pools don’t typically use weights. Because these pools are higher off the ground, the cover is usually tied down. This can be done by getting a cover that ties to the pool frame itself, or by putting stakes and tie downs in the yard around the pool to hold the cover in place.

Should a pool cover touch the water?

The cover is designed to touch the surface of the water. So your pool should always be filled when covered, and the water level should never go below 18 inches from the top of the pool. Check the water level of the pool and fill it up if it goes below 18 inches.

How do you install pool anchors in the grass?

Be sure to hold the drill perpendicular to the deck, to create a vertical hole. After drilling the hole, remove the dust with a blower, wet-dry vac or with a garden hose. Then tamp the anchor into the hole, using a tamping tool so you don’t damage the hex key hole, or bend the top rim of the anchor.

How far apart are pool cover anchors?

Set anchors back to proper distance from the pool edge. Anchors should be located 20” from the cover’s edge. The correct anchor distance back from the pool edge is the cover overlap plus the 20” distance from the cover’s edge to the anchor. Typically the anchors are about 32” to 38” back from the pool edge.

How do you remove concrete anchors?

Usually, a screwdriver, pipe wrench, or vise grips can unthread the protruding bolt, leaving the female anchor flush with the concrete. If needed, a hammer can be used to knock the anchoring tube below the floor, and in some cases these tubes can simply be pulled out of the hole entirely.