Electric ice auger can help you to drill several holes without causing any problem. Batteries power them, so there is no need to pull the starter cords. They do not produce any smoke and fumes and work quietly.
How long does an ion ice auger battery last?
From the Ion FAQs page: “The battery is expected to last about 600-800 full charge cycles before performance will be affected.” If you exceeded that in two years, you must live pretty far north!
What is the best cordless drill to use on an ice auger?
Quick glance at the best drills for ice augers:
Milwaukee 2804-22 M18 Fuel – Best Drill for a Convertible Auger. DeWalt 996P2 – Best Buy Drill for a Convertible Auger. Ridgid R8611503 Gen5X – Best Budget Drill for a Convertible Auger. Milwaukee 2803-22 XC M18 Fuel.
What can I use instead of an auger for ice fishing?
Here is a quick list of all the methods I have seen used to successfully cut through ice without an auger.
Axe.Spud bar.Digging iron.Pick axe.Chainsaw.Ice saw.
Can you use a drill for an ice auger?
The Drill You Need
What you already have might be perfect, but you want to make sure. Most of these 6- and 8-inch augers can be used perfectly well with your average modern 18-or-20-volt cordless drill.
Who owns Ion ice augers?
ION Ice Fishing is one of eleven outdoor brands created and sold by Ardisam, Inc.
Are ion Auger batteries interchangeable?
( XC5 -5 amp hour lithium ion battery) Emailed Ion/Ardisam they replied the new 5 amp hour battery will fit and work with all older model augers. You can also charge the new battery with your current charger.
How many holes can you drill with ion ice auger?
Said with 10-12 inches of ice can probably drill 6 dozen holes; with 2 feet of ice probably 3 dozen.
How long does it take to charge a ion Auger battery?
The battery takes between 2-3 hours for a full charge, but can sit on the charger overnight if needed. He did recommend not keeping the battery on the charger for more than 24 hours, however.
What size drill is needed for ice auger?
I believe they recommend drills capable of producing 700 in lbs of torque as the minimum.
How many pounds of torque does an ice auger need?
Re: Hand Drill Auger Ice Torque Requirement
The general recommendation is 700 in/lbs or better brushless drill
Do you need an auger to go ice fishing?
“Ice fishing can be kept simple,” says Thielen. “You need a good six-inch hand auger like a Strikemaster Lazer auger, until the ice hits eight inches thick.” Thielen repeated the need to drill down as straight as possible. “It’s much easier to cut through when drilling straight,” he said.
Can I use a chainsaw to cut through ice?
Yes, you can cut ice with your chainsaw. You don’t have to apply any mineral oil to prevent the water from pollution. To prevent the blade from rusting, you will have to look after your chainsaw.
