Because the clear coat acts as a sacrificial layer, the epoxy color coat will be protected. Without it, the colored epoxy coat can lose its luster from wear.
What is the difference between epoxy and clear coat?
Epoxy Clear top coats
The main advantage of epoxy for a clear top coat is cost. Epoxy is the least expensive option in most cases and as long as it’s not solvent based, it will be low in VOC’s as well. Epoxy can also provide for a thicker single coating of up to 10 mils depending on the solids content.
Can you put clear coat over epoxy paint?
Absolutely, epoxy takes other finish very well, as it is completely inert once its hardened. That looks great by the way. I have used spar varnish on top of epoxy for a boat before. I’ve also sprayed high gloss clear coat – if you have a hvlp spray gun, I recommend that over a can for better results.
How do you apply clear epoxy?
Spread a thin layer of a well-mixed epoxy by using a squeegee first and then use a brush to finish edges. You can also use the “W” method to ensure an even finish and go over it with a back roller to reduce air bubbles and help spread out any areas which might have excess epoxy.
How long after epoxy can you clear coat?
Allow a minimum of 24 hours dry time after coating with EpoxyShield Floor Coating before applying clear.
Do you need a top coat for epoxy?
Why do You Need a Clear Coat Over an Epoxy Garage Floor? An epoxy top coat improves the durability of the garage surface and helps to prevent things like hot tire pick-up and protects the floor from impacts.
Can I put Polycuramine over epoxy?
The short & simple answer is YES. Here is Why? Polycuramine Coatings combine the best of Polyurea, Urethane and Epoxy chemistries. This gives them a huge edge over Epoxy…and Polyurea for that matter.
Do you put polyurethane over epoxy?
Polyurethane is a good sealant, and you can confidently put it over epoxy. You’ll need two to four coats of poly to make your project shine.
What is a clear coat?
The clear coat is a transparent layer of paint that can be used to cover the colored coat. The clear coat is usually the last coat of paint that is applied to a panel.
What kind of roller do you use for epoxy?
Generally, it is a good idea to choose a lint free woven roller with a 3/8 inch or 3/16 inch nap. When you use this type of roller, it will not shed into your epoxy, unlike other products. This is another common problem contractors have when applying epoxy products.
How much epoxy do I need for a seal coat?
General Rule: Most (but not all) coating epoxies cover approximately 12 square feet per mixed gallon (1/2 Gal Part A and 1/2 Gal Part B) at 1/8 inch thickness. A seal coat is an extra layer of epoxy, albeit a thin one.
