Installs in only 10 minutes:
Pre-assembled in frame for effortless surface mount installation. Place on opening and secure with pre-attached screws.
How do you install Larson storm door screw strips?
Apply Screw Cover Strips
Snap the screw cover strips into the mounting rails by installing the outer side first. Start at one end and slide your finger along the strip while pressing down. And with that, your new storm door is installed.
Is it hard to install a storm door by myself?
New storm doors are easier to install, with plenty of standard sizes to fit almost any entryway—but there are still tricky spots. Follow a pro through the installation process and learn the tricks and techniques that the instruction manual doesn’t cover.
Is LARSON and Pella the same company?
Another note is that the Pella storm door line was recently bought out by Larson Storm doors. Now, Pella storm doors are made by Larson, and are available at Lowe’s stores nationwide. The good news is they’ve taken the best of both lines and are combining their doors.
Who manufactures LARSON storm doors?
LARSON is now part of Fortune Brands’ Outdoors & Security segment. The Company completed the acquisition for a price, net of tax benefits, of approximately $660 million, which was funded with cash on hand and borrowings under its revolving credit facility.
How do you tighten a Larson storm door handle?
There is a flat head screw on the top of the closer. Turn it to the right until it is tight. Then turn it left one full turn.
Where is the model number on a Larson storm door?
The serial number for your storm door is located on a factory-applied label on the hinge rail and should be visible when the storm door is in the open position (see image to the right). If you are unable to locate the serial number on the hinge rail of your storm door unit, look around the perimeter of the storm door.
Do Larson storm doors come with hardware?
Hardware kit includes the necessary items needed to replace the mortise hardware on your LARSON® full glass door. Comes with a built-in deadbolt lock and matching interior and exterior levers.
How do you remove the retainer strips on a Larson storm door?
Some retainers will have a slot cut into them for this. Next, tilt the screw driver at a slight angle, tipping the handle towards the door frame. Tap the end of the screwdriver until the end of the retainer pops out of the track. Then grab the retainer and remove it.
How do you remove the retainer strips from a storm door?
Hold the outer lip of the retaining strip on the left side of the door. Pull the strip downward and toward the door glass until you have pulled off the entire strip. Repeat this process for the strip on the right side of the door.
What side should a storm door be installed?
Storm doors can open from the left or the right. Most storm doors can hang with the hinges on either side using the same Z-bar.
Should storm door handle be on same side as door?
When installing a storm door, the storm door handle and the entry door handle are located on the same side. If the jamb depth measurements are less than those required to properly mount your storm door, then the storm door handle may interfere with the entry door handle.
What tools do I need to install a storm door?
Tools: Power drill, hammer, hacksaw, level, screwdriver, sawhorses, spirit level, measuring tape. Open up the box containing the storm door unit and find the instruction manual.
Who owns Pella storm doors?
Today, Pella Corporation is still owned by the Kuyper family, and continues to be a leader in technology and product innovation. In fact, we’ve been awarded more than 150 product and design patents.
