Turn the dial to the “Auto” position and move the slide switch for the desired valve up to the “Manual On” position to test valves on Orbit’s “Individual Station Slide” timers. To test all the valves in sequence, simply press the “Manual” key and press “Enter.”
How do you troubleshoot an orbit sprinkler system?
Turn the flow-control stem located at the connection from the Orbit to the main water line in a counterclockwise direction if one or more of the sprinklers is not responding to programming. If the problem persists, check the wired connections of the device to make sure they are correct.
How do you manually turn on orbit sprinklers?
To open the valve manually, twist the manual bleed screw counter-clockwise until the valve opens. It usually doesn’t need to be more than one-half turn. To close the valve turn the manual bleed screw clockwise until the valve closes.
How do I turn on my orbit sprinkler system after winter?
Steps to turn on sprinkler system after wintering
Find system’s main shut-off valve. Find the vacuum breaker. Close the vacuum breaker test valves. Open the vacuum breaker’s shut-off valves. Reinstall main valve bleeder cap (as needed). Slowly open the main valve. Test the system. Recheck the vacuum breaker and valves.
Should sprinkler valves be open or closed?
Make sure the sprinkler valve is closed, unless it’s the valve farthest from the main water source. You’ll want to leave this valve open and remove the sprinkler nozzle to allow air to escape when you turn on the water.
Why is my sprinkler timer not working?
If your sprinklers aren’t working but the timer is on, the problem could be a fuse. (Not all timers have fuses, but some older ones do.) Open the sprinkler timer box to check the fuses; if any are broken, replace them. The problem could also be the sprinkler system’s antenna, which is often powered by a 9-volt battery.
How do I know if my sprinkler timer is bad?
Sprinkler System Troubleshooting — 5 Signs Of A Faulty System
Controller Isn’t Working Properly.Low or High Water Pressure.Sprinkler is Stuck or Won’t Come Up.Puddles on Lawn or Around Sprinkler.Uneven Spray Patterns.When to Call a Professional.
How do I reset my sprinkler timer?
How to Reset a Sprinkler System
Turn the control dial to the “off” position.Press the “next” button to access the clear-memory feature. Press and hold the “off” button until the display stops blinking.Turn the control dial to the “run” position.Press and hold down the “minus” arrow and “prog” buttons simultaneously.
What does no AC mean on orbit sprinkler timer?
The NO AC display is a diagnostic message telling you that the controller has stopped receiving AC power. The controller is running on the power supplied by the backup battery. Check the power source by plugging a lamp or radio into the wall outlet to verify there is power at the outlet.
How do you turn off orbit sprinkler heads?
Turn the sprinkler off. Use a pull up tool to lift up the metal screw on the center of the nozzle. With the screw loose, the sleeve can be turned clockwise until it comes off. At the same time, turn the nozzle counterclockwise.
How do I turn my sprinkler back on in the spring?
Slowly open the main shutoff valve to let water into the sprinkler system. For a ball valve, turn the lever handle one-quarter turn until the handle is parallel to the pipe; this is the fully open position. For an in-ground shutoff valve, use a sprinkler valve key to turn the valve counterclockwise until it stops.
Can I turn on my sprinkler system myself?
It’s easy to turn on the sprinkler system at your home and you can easily turn them on yourself, right? Wrong! A common misconception among homeowners is that a spring start up for a sprinkler system is “just turning on the valve”.
