Minwax® Wipe-On Poly provides a durable layer of topcoat protection but it is thinner than regular polyurethanes. It can be used on floors to touch up small areas that are worn or scratched.

How long does it take for Minwax Wipe on Poly to dry?

Apply a liberal amount of Wipe-On Poly to a clean, soft, lint-free cloth and rub it into the wood. Let dry 2-3 hours. Then lightly sand entire surface with fine sandpaper (220 grit) to ensure an even finish and proper adhesion. Remove all dust.

How do I get a smooth finish with Wipe on Poly?

Wash it first with dish soap and water, then lightly sand the old finish with 220-grit sandpaper. Vacuum off the dust, then apply the finish as usual. Apply at least two coats to achieve an even sheen.

How long between coats of Minwax Wipe-On Poly?

How Long to Wait Between Coats While Applying Wipe On Poly? It’s recommended that you wait for at least two to three hours before applying the next coat of wipe on poly.

Can you use Minwax Wipe-On Poly over paint?

Can You Use Wipe On Poly Over Acrylic Paint? Yes, there is a answer to that question. polyurethane over acrylic paint, whether it’s oil-based or water-based. The brightness of the paint will be restored and the glossy finish will be achieved by applying polyurethane.

Do you wipe off Wipe on Poly?

A margarine or cottage cheese tub is just right for wipe-on. Dip your rag into the finish, squeeze out the excess and wipe on. With the lid in place, the poly will remain fresh for a couple days. After a few days, the solvent will begin to degrade the plastic, so don’t use plastic for long-term storage.

Do you sand between coats of wipe on poly?

The issue with sanding between wipe on coats is that they are extremely thin coats, so in general, you’ll only want to sand with very fine abrasives if your last coats were applied beyond the re-coating window listed in the product instructions.

Is Wipe on Poly waterproof?

Hello, In Chris Minick’s article on wipe on finishes, the table suggest that Minwax Wipe-On Poly has excellent waterproof characteristics.

What kind of rag do you use for Wipe on Poly?

I like to use 220 grit, but you could use a higher grit like 320 if you want. You could also use 0000 Steel Wool. One you are done sanding, wipe off any dust with a lint-free cloth or a micro-fiber tack cloth.

Can you apply Poly with rag?

Yes. It’s easy to apply Polyurethane with a rag. When applying, never saturate or sop up all the paint (leave behind some). Apply thin coats.

Do you use steel wool after polyurethane finish?

Using steel wool or sand paper allows you to create a uniform surface for the next coat of polyurethane, which generally looks nicer, more professionally, etc. In my experience, assuming the finish is dry, there isn’t a difference other than the coarseness of the sand paper or steel wool.

Should I sand after first coat of polyurethane?

Sand the dried and cured first coat of polyurethane no sooner than 24 hours after applying it. Use a very fine-grit abrasive, sanding with the grain of the wood. Remove the sanding dust first with a static duster, followed by a tack cloth.

How long does it take for Wipe-On Poly to cure?

Dry and recoat times are based on 70ºF and 50% relative humidity. Wipe-On Poly will dry to the touch in 2-4 hours, to handle in 8-12 hours and can be recoated in 4-6 hours. Full cure will be achieved in 24 hours.