Launch the Rain Bird app and press the Add Controller button. Follow app prompts to set up WiFi connection to Rain Bird controller. Share access to the controller as needed.
How do I connect my Rainbird to WiFi?
How to setup the Rain Bird LNK WiFi Module and the mobile app
Download the Rain Bird App.Check the signal strength at the controller location. Insert LNK WiFi Module into the Accessory Port on compatible controller models.Verify LNK WiFi Module is alternating blinking red and green.
Does my Rainbird have WiFi?
Rain Bird now offers the LNK™ WiFi Module for Residential and Light Commercial Rain Bird controllers. The New Rain Bird LNK WiFi Module allows easy access and control of a Rain Bird irrigation system from anywhere in the world.
How do I reset my Rainbird LNK WiFi module?
Reset the WiFi module. While plugged in, press and hold the button on the WiFi module for 5 seconds. The LED should turn Amber colored, and then red, followed by three green blinks, followed by red and green alternating (WiFi Hotspot).
Is Rainbird ESP RZX WiFi Compatible?
Rain Bird ESP-RZX Series Controller WiFi Compatible
Available in 4, 6 and 8 stations the ESP-RZX is the Outdoor controller for you. Contractor grade, this fixed station irrigation controller is for light commercial and residential use.
Why is my Rain Bird not connecting to WiFi?
This can be caused by several factors: The controller is not connected to an Internet connection properly within your home WiFi network The controller is unable to establish a connection with the Rain Bird server Your mobile device’s controller password does not match the controller (password reset required).
Does Rain Bird have an app?
The Rain Bird mobile app pairs seamlessly with your Rain Bird controller to allow you to monitor and edit your irrigation system from anywhere in the world. Using the app, you can adjust your system’s schedule, manually water zones, share access to your system with family members, friends, contractors, and more.
Why is my Rain Bird not working?
Circuit breaker/fuse – Check the condition of the circuit breaker or fuse, if it has been blown the most likely reason is a field wiring short. An Electromechanical controller will stop on the station that caused the problem. Reset the controller to its rest position and replace the fuse or reset the circuit breaker.
Why won’t my Rain Bird controller connect?
If you are unable to connect to the controller, try pulling the WiFi module out of the controller and re-inserting it, allowing it to boot back up again. It should be blinking green when you try to connect in the Rain Bird app.
What is the Rain Bird controller password?
The controller password is restricted to letters and numbers, 4-8 digits in length. No special characters. If you use a special character it will not be registered in the password. As an example, if you typed in 1234@, the password would be stored as 1234.
How do you reset a Rain Bird sprinkler system?
Turn the dial to Seasonal Adjust. Press and hold the left and right arrow buttons at the same time for at least 3 seconds. Until you see the word “CLEARED” on the screen. Your ESP-Me is now restored to the factory default settings.
How do you clear the alarm on Rain Bird ESP?
In the Auto dial position select Alarm and Clear. Manually start the problem station.
How do Rain Bird rain sensors work?
How rain sensors work. The two leading manufacturers of irrigation products, Rain Bird and Hunter, both make rain sensors and both detect rain using the same method. They have a series of porous cork discs that when they get wet from rain, they expand and force the sensor to prevent the controller from watering.
