The Epicenter restores the earth-shaking power and heart-pounding bass your subwoofers crave. Give your subwoofers the juice to go lower and hit harder. The Epicenter uses a bass circuit to drive your subwoofers lower, grabbing the attention of every eye on the boulevard.
What is better equalizer or epicenter?
We always recommend you put the Epicenter® BEFORE an EQ or crossover. Since the Epicenter is adding frequencies to your signal, you would want to put it before any EQ or crossover in order to be able to adjust those frequencies.
Is the epicenter a crossover?
A crossover filters out certain frequencies that you don’t want your speakers to play. Like setting a low pass filter to just play 80hz and below and the high pass 80hz and up. The epicenter is a bass restoration processor. It basically boosts bass.
What is an epicenter subwoofer?
THE EPICENTER® CONCERT SERIES
The Epicenter restores the earth-shaking power and heart-pounding bass your subwoofers crave. Give your subwoofers the juice to go lower and hit harder. The Epicenter uses a bass circuit to drive your subwoofers lower, grabbing the attention of every eye on the boulevard.
Are digital bass processors worth it?
Is it worth it? Depends on what you aren’t getting out of your system or music. If you listen to a lot of music that lack bass and want so, it might be ok. It’s not very faithful to the original recording (by design) but it can give some satisfying low end to older recordings.
Do I need a crossover and equalizer?
Crossover and equalizer are two of the advanced level car audio components. It means while they’re not as critical as speakers or amp, and you’d be fine if skip them, they can make your car sound from good to GREAT.
How do you connect an equalizer to a crossover?
Plug the preamp or mixer main output into the equalizer input with a shielded interconnect cable. Connect the equalizer output to the crossover input with a shielded interconnect cable. Plug shielded interconnect cables into each of the crossover’s labeled frequency outputs.
Can I use speaker wire for epicenter?
Unlike speaker cables, which can be routed directly next to existing car wiring, we also recommend that you route line level (coaxial) wiring between the head end unit and the Epicenter away from car wiring, amplifier power supply cables or speaker wires if possible.
What does wide and sweep on epicenter?
The two knobs are labeled “Wide” and “Sweep”. The “Sweep” knob allows you to pick the center frequency that you want The Epicenter bass restoration circuit to “maximize”. The “Wide” knob adjusts how wide a frequency range The Epicenter will effect.
What is a synonym for epicenter?
attraction, lodestone. (also loadstone), magnet, polestar.
What goes first equalizer or crossover?
When using both an equalizer and a crossover the equalizer is connected before the crossover.
What does a bass restoration processor do?
Although adding a subwoofer to your car audio system will definitely allow you to hear more of those low frequencies, a bass restoration processor digitally restores that heart-pounding bass that is still missing from your music.
