A factory reset will delete all codes associated with the lock.
Make sure the door is open and unlocked.Press and hold the program button for 30 seconds using the SmartKey tool or a paper clip. You will hear one long beep.Press and release the program button. You will hear one short beep.
How do you change the 4 digit code on a Kwikset lock?
It is recommended that you change it to a code of your own.
Make sure the lock is unlocked and the door is open.Enter your Programming Code – for new installation, default is 0-0-0-0.Press enter arrow. You will hear one beep.Press 4 .Press enter arrow. You will hear one beep.Enter a new Programming Code.
What is the master code for Kwikset?
The default Mastercode is 0-0-0-0. It is recommended that you change it to a code of your own. 1. Make sure the lock is unlocked and the door is open.
Where do I find my Kwikset key code?
First, check both sides of your key. Some key codes are stamped into the key. If you do not find your key code there, try contacting your contractor (this should be on file with him/her). Lastly, you can take your key to a locksmith to determine the key code (usually a free service).
How do I change the code on my electronic door lock?
First, open the door and lift off the lock’s interior cover. Press the Program button once and you should hear your unit beep five times and see its checkmark icon at the keypad’s bottom left flash five times. Press the checkmark once and then enter the master code.
How do I change my Kwikset lock code without master code?
If you do not have the master or user code you may do a factory reset on the unit to program a new master code into the lock. The link provided will guide on how to factory reset the lock and program the lock.
How do you reset a Kwikset lock code 909?
How to restore default settings on my Signature Series or SmartCode Deadbolt? Perform a factory reset
Remove battery pack.Press and HOLD the Program button while reinserting the battery pack. Press the Program button once more. Perform the door handing process again to teach the lock the orientation of the door.
How do I reset my Kwikset lock code 913?
How do I program my SmartCode 913 lock?
Open the door.Remove battery cover.Press the program button once.Enter new user code.Press lock button.If programming is successful the keypad will flash green once, and you will hear one beep.
How do you reset a Kwikset 916?
Press and HOLD the Program button while reinserting the battery pack. Release button once battery pack is installed. The status LED will flash red and green. Press the Program button once more.
How do I reset my Kwikset touchpad electronic deadbolt?
Hold the button continuously for 30 seconds until you hear a beeping sound and see the status LED flashing red. Press the program button once again until you see the status LED flashing green and hear two beeping sounds. The Kwikset SmartCode deadbolt has now been reset and ready to be set up again.
