The general rule of thumb is that the screw should enter at least half the thickness of the bottom material, e.g. 3/4″ into a 2 x 4. The other factor is the screw’s diameter, or gauge. Screws come in gauges 2 through 16. Most of the time you’ll want to go with a #8 screw.

Should a drill bit be the same size as a screw?

Choose the right size drill bit.

If you are creating a pilot hole for a nail, the right drill bit is slightly smaller than the nail’s shank. If you are creating a pilot hole for a screw, the drill bit should be the same size as the body of the screw—not including the threads.

What is the most standard screw size?

The most common size is #8 (approximately 5/32-inch in diameter), but the appropriate size of screw will depend on your individual project.

The drill bit should be the same size as the shaft of the screw without accounting for the threads. To do this, simply line up a screw side by side with the drill bit. If they’re the same size, then you’re good to go.