Console & Indicator Diagnostic Test Mode
The washing machine should be in standby (off) mode.Press and release the following buttons within 4 seconds. if successful “dt” should display on the washing machines indicator.Within 5 seconds press “Start” all indicator lights should come on and 88 should be displayed.

How do I reset my Whirlpool Cabrio washer?

Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset.

Is there a way to reset a Cabrio washer?

Press the Start Stop button once. Rotate the dial until Rinse, Wash, and Stop light illuminate. Turn the washer off and unplug it for 10 seconds. Finally, turn on the washer and it should now be reset.

How do you clear the error code on a Whirlpool top load washer?

Press START/PAUSE once to clear the code, then press START/PAUSE again to restart washer. If the code doesn’t clear, Contact Us or Schedule Service Online.

What does F mean on my Whirlpool washer?

An F error code usually means the washer will not work at all, and the control board will need to be replaced.

Do Whirlpool washers have a reset button?

Follow these steps to reset a Whirlpool washing machine: Make sure the power to the washer is turned on at the wall, but keep the Power button on the control off. Hold the Program button down while simultaneously pressing the Water Level button two times. When done correctly, the control panel lights should illuminate.

How do you do a factory reset on a washing machine?

To reset your washing machine, unplug it from the power outlet. Then, plug the washer cord back into the wall. Finally, open and close the washing machine door six times to send the reset signal to the system components.