KE-155R
Enter your vehicle and close the doors and trunk behind you. Insert the key into the ignition and switch it from “Off” to “On” three times, ending in the “On” position after the third cycle.Push the valet switch on your Autopage alarm twice. Press any button on your keyless remote starter.
Who makes autopage remote start?
Auto Page, maker of remote starters, and its owner Varad, maker of automotive lighting, closed their doors almost two weeks ago, and laid off all remaining personnel with the exception of VP Carl Stacy, said industry members.
Can you remote start with OBD2?
Simply plug in to your OBD2 port and you can start your vehicle remotely by pressing lock-unlock-lock on your factory key fob! ✅ NO NEED FOR EXTRA DEVICES – Start your vehicle with clicking LOCK UNLOCK LOCK on your factory remote.
How do I use autopage xt12 remote start?
Turn the Ignition ‘switch ‘OFF/ON’ 3 TIMES and stay in the ‘ON’ position. Within 15 seconds. Push the Programming switch 2 times holding in on the 2nd push, until a long chirp from the horn (optional) and the LED starts to flash then release the valet switch. You are now in the Transmitter programming mode.
What is the valet switch on autopage?
The valet button or switch permits the owner to temporarily bypass the alarm functionality of the system. To enter or exit valet mode, disarm the system with a working transmitter, your personalized manual override code, or using the procedure below which is to enter or exit valet mode.
Why is my remote car starter not working?
If your remote starter system isn’t working properly, try replacing the battery in your fob. You can find replacement key fob batteries at Batteries Plus. Most remote starter fobs run on 2032 lithium coin cell batteries. This one may seem obvious, but if your vehicle is not in “Park” your remote starter will not work.
Is remote start easy to install?
Remote starters are convenient, inexpensive and easy to install. Learn about remote start installation here. Install a remote starter for your car yourself. It’s a great upgrade, inexpensive and a project you can do yourself with simple tools and the supplied wiring diagram.
How many OBD2 protocols are there?
OBD-II Protocols
An OBD2 compliant vehicle can use any of the five communication protocols: SAE J1850 PWM, SAE J1850 VPW, ISO9141-2, ISO14230-4 (KWP2000), and since 2003 also ISO 15765-4/SAE J2480. ELM-USB and OBDTester support all of them.
How do I program my h50t21?
PROGRAMMING INSTRUCTIONS :
Turn the Ignition ‘switch OFF/ON 3 TIMES and stay in the ON position. Push the Programming switch 2 times holding in on the 2nd push, until a long chirp from the horn (optional) and the LED starts to flash then release the valet switch.
How do I turn off valet mode on autopage?
1. Return to normal operation, turn ignition ‘ON’. 2. Push and hold valet switch for 2 seconds; the LED will turn off indicating the system is exiting the valet mode.
How do I know if my car is in valet mode?
Insert your vehicle’s key into the ignition and fully start the engine. Press and release the foot brake pedal 10 times within 10 seconds. If you see/hear two parking light flashes/clicks, you have exited valet mode.
Where is the valet switch located?
Typical locations for valet switch: Under the driver’s side dash (mounted in the under-dash covering trim panel or wire-tied to a harness) Mounted in the driver’s side kick panel. Mounted in the steering column plastic housing.
