The “F5” error means that the temperature sensor has recorded an unusual reading while using hot water. This usually is a sensor error rather than a malfunction of your hot water heater.
What does the Code F mean on a Whirlpool washer?
An F error code usually means the washer will not work at all, and the control board will need to be replaced.
How do I reset my Whirlpool front load washer?
Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset. You can run a test load without any clothing to ensure that the reset worked.
What does e5 mean on Whirlpool washer?
This alert indicates the load is out of balance. The washer is running a load-balance correction routine. Allow the washer to continue. If the dial is flashing and the washer has stopped, redistribute the load, close the lid, and press START/PAUSE.
What is E1 error in Whirlpool washing machine?
E1 Error code means the correct water level has not been reached within 20 minutes of the washer starts.
How do I clear E1 F9 code?
How to Fix Whirlpool Washer E1/F9 Error Codes
Try a Reset. Sometimes an error code is caused by a control board glitch, where resetting the washer is all it takes to resolve the error code. Check your Detergent. Check the Drain Hose. Clean the Filter. Check the Drain Pump. Check the Wiring.
What does E1 and F9 mean on a Whirlpool washer?
If F9 E1 (drain pump system problem – long drain) appears in display, the washer is taking too long to drain water. The drain may extend more than 4.5″ (114 mm) into standpipe. Check plumbing for correct drain hose installation.
What does F5 and E3 mean on a washing machine?
The F5 E3 alert indicates there is issue with the lid lock. Do not force the lid open, as permanent damage could occur. Remove any objects from the lid and clear any obstructions. Touch POWER to exit cycle, then touch POWER again to release lid.
What is E2 and F5 Whirlpool washer?
The F5 E2 alert indicates the washer can’t engage the lid lock because there may be an obstruction in the lid lock area. Please check the lid lock area and remove any objects in that area. Also verify there are no clothing items in the way.
What does E3 mean on a Whirlpool washer?
If you receive an E3 Error code, your washer may be unbalanced. This could be caused by the washer being too tightly packed, or clothing not distributed evenly. This will usually occur during the spin cycle. Stop the spin cycle.
What does F 02 mean on a washing machine?
The F02 error code on a Whirlpool washer indicates that the control detects a long drain time. This can be caused by excessive suds in the tub, a restriction or clog in the drain system, or by a number of other component failures.
How do I fix the f5 on my Whirlpool washer?
Remove any objects from the lid and clear any obstructions. Touch POWER to exit cycle, then touch POWER again to release lid. If this is unsuccessful, reboot the machine by unplugging the washer and wait two minutes before plugging the machine back in.
What does F code stand for?
In ICD-10, the diagnostic codes that start with the letter “F”, cover the category of “Mental, Behavioral and Neurodevelopmental disorders”.
