Poulan Pro Fuel Line Kit No.
Comes with a large 3/16″ OD by 3/32″ ID 2 feet long, small 9/64″ OD by 5/64″ ID 2 feet long. Also comes with the fuel line fitting connector.
What size is Craftsman chainsaw fuel line?
Fuel Line (Small)- 9/64 (. 140) inch OD – (. 080) inch ID, W/ Installation instructions. Fuel line kit.
How do you replace a gas line on a chainsaw?
Instructions
Drain the fuel tank. Wear work gloves to protect your hands. Remove the cylinder shield. Disconnect the spark plug wire and remove the air filter. Remove the fuel filter. Remove the carburetor. Remove the old fuel lines. Install the new fuel lines. Install the fuel filter.
Which fuel line goes to the primer bulb?
For this 2-stroke engine carburetor design, the primer bulb is built on top of the assembly. The bulb pulls fuel through the filtered fuel line and into the carburetor and then it also pushes it out of the carburetor and out the unfiltered return line.
Can you run a chainsaw without a fuel filter?
While it’s possible to run your chainsaw without a fuel filter, but this is not recommended. When a fuel filter is clogged, it can cause considerable damage to the engine and leave your chainsaw unusable.
What size are the fuel lines on a Craftsman leaf blower?
Fuel Line (Small)- 9/64 (. 140) inch OD – (. 080) inch ID, W/ Installation instructions.
How do you replace the gas lines on a Poulan chainsaw?
How to Replace the Fuel Return Line on a Poulan Chainsaw (Model P3314)
Let’s get started. Remove the top cover.Remove the air filter housing.Remove the carburetor.Remove the fuel return line.Cut the new fuel line to the proper length.INSTALLING THE NEW FUEL RETURN LINE [top] 7. REASSEMBLING THE UNIT [top] 8.
How does a primer bulb work on a chainsaw?
Some chainsaws use a primer bulb to help suck gas into a cold carburetor. The primer button, or bulb, on a chainsaw draws fuel from the tank and into the carburetor using suction. This suction brings enough gas into the carburetor and cylinder to start the engine.
Which fuel line is the return line?
The vapour-return line normally runs from the fuel pump or the fuel filter to the fuel tank. This vapour-return line is connected to a special outlet in the fuel pump. Any vapour that forms in the fuel pump returns to the fuel tank through this line.
