You can check by looking for a few signs that a pump is dying or already dead.
Start the washer and wait for the washer tub to fill with water. If you do not hear water or hear a motor whirring, the washer motor may be dead.Open the washer lid in mid-cycle. Wait for the washer to finish its cycle.

How can I tell if my washing machine pump is broken?

Put your finger into the drain outlet and feel the impellers if the pump freely turns. One or more of them may be broken. If so, you’ll be able to feel them while you’re turning the pump flywheel with your other hand. You also may see broken pieces of plastic in the bottom of the pump housing.

How do I know if my washing machine drain is clogged?

Test the drain by pouring water into it, if it has been backing up. If it’s clogged, you should be able to clear the clog with a plumbing auger.

What causes a Whirlpool washer not to drain?

When the drain hose is kinked, bent, blocked or clogged, the washer won’t drain. To handle the blockage problem, disconnect the drain hose and give it a good cleaning. Then, reconnect the drain hose to the machine, turn the electricity back on and run the rinse/spin cycle to see if the washer is draining properly.

How much does it cost to replace a drain pump on a washing machine?

On average, expect to spend $300 to $400 for a pump replacement job. Washing machine pump repairs are usually required when you note active leaks or a tub that doesn’t drain. If the tub does not move, but the agitator does, this indicates the pump is starting to experience issues.

Where do I find model number on Whirlpool washer?

Find the model and serial number for your Whirlpool washing machine either beneath the washer lid, or on the rim of the tub.

Where is the water pump on a Whirlpool washer?

Grab both sides of the bottom panel with your hands. Pull down on the panel while pulling the bottom of the panel away from the washer to expose the water pump.