APPLICATION: Apply CONCRETE LEVELER up to 2″ (5.1 cm) thick. For thicknesses greater than 2″ (5.1 cm), extend each 50-lb (22.7-kg) bag with 25 lb (11.3 kg) of clean, dry 3/8″ (0.95 cm) pea gravel. When extended with aggregate, CONCRETE LEVELER may be placed up to 5″ (12.7 cm) thick.

How much does a 50 lb bag of self leveler cover?

Coverage: One 50 Lb. bag will cover approximately 40 Sq. Ft. at 1/8 In.

How thick should you pour self leveling concrete?

QUIKRETE® Fast-Setting Self-Leveling Floor Resurfacer (No. 1249-51) can be installed from 1-1/2 inch (38 mm) thick to a feather edge, although a ¼ inch (6.3 mm) minimum thickness is required for heavy traffic areas.

Do I need primer for self-leveling compound?

Self-leveling underlayments require the use of a primer prior to installation (like the TEC Multipurpose Primer). Failure to use product recommended primer may result in installation failure. Primer retains the moisture within the self-leveling underlayment to allow proper curing.

How long does rapid set concrete leveler primer take to dry?

Apply Concrete Leveler after the primer is dry (usually 30 minutes to 3 hours) and within 24 hours of the final primer coat. If more than 24 hours have elapsed, reapply primer. COVERAGE & PACKAGING: CLP is available in 1 quart and 1 gallon bottles.

How thick can you apply self-leveling compound?

It depend on the particular floor leveling product you’re using, but most manufacturers recommend that you apply no more than 1/8” thick coat of self-leveling or floor patch compound at a time.

Does floor leveler crack?

A DIY self-levelling cement job might look good for a few months, maybe even a couple years. But if it’s not done properly, eventually it can start to crack.

What is the cheapest way to level a concrete floor?

The cheapest way to level a concrete floor is to use a specialized sand mix. This sand mix is 90% more affordable than self-leveling concrete while producing similar results. To do this, you will spread the sand mix across the top, spray it with water, and then let it dry.

Can you pour self-leveling concrete over existing concrete?

You can pour self-leveling toppings or self-leveling overlays over concrete surfaces you didn’t think were salvageable, saving time and money. “It’s faster and easier than pouring new concrete,” says Paul Koury, president of Westcoat Specialty Coating Systems.

How deep can you use self leveler?

Suitable for use on most common subfloors such as sand/cement screeds or concrete. It has high flow properties making it ideal for smoothing. It can be laid up to 6mm in depth.

Can you paint rapid set concrete leveler?

Answer: Rapid Set reduces the waiting time before coating. Under dry conditions water-based coating materials such as latex paint can be applied as soon as the product is hardened and dry which usually takes 1 – 4 hours.

How do you use self-leveling primer?

The floor needs to be primed before adding the floor leveler and you’ll want the primer to soak into the floor, not the dirt and dust sitting on top of it. Keep a marker or roll of tape in your pocket while you’re vacuuming, and mark all the holes or cracks in the wood that will need to be sealed up.

What happens if you add too much water to self-leveling concrete?

When excess water is used in cement-based mortars, grouts, levelers or patches, it increases spacing between the molecules of the mixture and stops the fingers from interlocking tightly, weakening the cement. This can lead to shrinkage cracks, along with decreased flexural and tensile strengths.