Samsung Washing Machine Error/Fault Codes
5E/SE – Draining Problems. 4E – Not Enough Water Entering Machine. dE or DC – Open Door. UE – Unbalanced Load. 3E – Faulty motor tacho. bE – Motor triac short error. OE – Too much water in machine. LE – Water Leak.
How do I reset my Samsung front load washer?
What you can do instead is power cycle it: Unplug it (or turn off power at the circuit breaker), wait some time for the electrical charge to clear out of the washer (usually 1 to 5 minutes at most), and then power it up again. This is the closest you can get to a “reset” of the washer.
Why are the lights flashing on my Samsung washing machine?
Samsung washer spin light blinking
For the most part, this is due to improper installation of the washer or failing to balance the load. For that reason, work on balancing the load size (as explained earlier) and ensure the selected type of cycle matches what you’re washing.
How do I troubleshoot my Samsung washer?
Troubleshooting
Unplug the machine. Disconnect the hoses.Remove the detergent drawer by pressing the central locking button.Open the hatch of the drain filter at the bottom of the front panel.Empty the water and clean the filter.Put the washer on a side so that you can access the bottom.
How do I fix the OE error on my Samsung washing machine?
And the OE code appears on the display of the Samsung washing machine. To eliminate the false overflow error due to foam, turn on the spin mode to drain the water completely, remove the laundry and run the machine in rinse mode to rinse the drum. Then, to check, turn on the wash again without laundry and powder.
How do I fix my Samsung washer error code 3E?
How To Fix 3E Samsung Washer Error Code:
Unplug The Washing Machine: Unplug the washer for 2-3 minutes. Check Wire Connections On Drive Motor: One fairly common issue that causes the 3E error code is connection problems. Check Wire Connections On Control Board: Check Hall Sensor:
How do you do a factory reset on a washing machine?
To reset your washing machine, unplug it from the power outlet. Then, plug the washer cord back into the wall. Finally, open and close the washing machine door six times to send the reset signal to the system components.
Is there a reset button on a washing machine?
Most newer washing machines come with a reset feature that allows you to restart the washer after it experiences an error code or fault. Causes that lead to these problems include power spikes, imbalanced loads or an interruption in power. Some machines have a button you push to reset its motor.
Why is my Samsung washer not spinning or draining?
If your washer doesn’t drain or spin:
Make sure the drain hose is straightened. If you have a kink in the hose, it may restrict any water from draining. Make sure the debris filter is not clogged. If you are able to open and close the door, close it and press START/PAUSE.
What is 4E error in Samsung washing machine?
The 4E (4C) error indicates that the washing machine has detected that there is a problem with the water supply. The most common reason for this error is a blocked or kinked water supply hose.
Why is my Samsung front load washer not spinning?
A malfunctioning lid switch is one of the more common reasons you have a Samsung front load washer not spinning. The lid switch is a safety mechanism that prevents the motor from starting if the washer door is open.
Why does my Samsung washing machine keep stopping mid cycle?
Common solutions for: Samsung Washer stops mid cycle
If the washer door is not latched shut, the door switch prevents the washer from operating. If the door lock is defective, the washer may stop mid cycle. The door lock can fail either mechanically or electrically. Inspect the door lock for damage.
