.

Also question is, how do I adjust the pressure on my toilet?

With the water supply off, flush the toilet and gently lift up the flush rod. Measure the clearance from the top of the actuator to the bottom of the flush rod. To adjust, loosen the actuator setscrew and raise or lower the actuator by rotating it clockwise or counterclockwise.

Likewise, how do you adjust a Gerber toilet? How to Adjust the Water Height on a Gerber Toilet

1. Remove the tank cover from the back of your Gerber toilet.
2. Locate the water level adjustment screw.
3. Use a pair of pliers to turn the screw and adjust the level of the water.
4. Remove the cover from the back of your Gerber toilet tank.
5. Rotate the adjustment rod on the fill valve 90 degrees.

Hereof, how do you replace a flushmate 503?

Installing a Replacement Flushmate System

1. Turn off the water at the supply stop.
2. Disconnect water supply line from the supply shank (bottom left-hand side of toilet tank) and remove the plastic nut that holds the supply shank in place.
3. If necessary, disconnect the flush-rod from the flush-handle linkage.

How do I make my toilet flush stronger?

A tube coming out from either the wall or the floor should contain the water supply valve. Turn the knob of the valve to the right to completely shut off the water. Next, pour a gallon of bleach into your toilet bowl and let it sit for 15-20 minutes max. After you let the bleach sit, go ahead and flush the toilet.