.

Moreover, what are Test caps?

View More Info. Oatey End-Cap Test Caps are a solvent weld test cap designed for hydrostatic pressure testing up to 17 PSI or 40' head pressure and can be used on schedule 40 ABS o

Similarly, how do you remove a knockout from a washing machine? Put the tip of a flathead screw driver on the knockout, and tap the back of the screwdriver with your hand or a hammer. Try to get it so that only part of the knockout breaks free. Then grab the loosened disk with a pair of pliers, and twist it free. Be very careful not to drop it down the drain.

Also, how do you install a test plug?

Align lugs on test plug (just above O-Ring) with slots in clamping collar. Push plug through collar. Thread plug into collar until O-Ring contacts pipe stop, Then give 1 Full turn only. Do not over-tighten.

How do I install a washing machine drain?

Washer Drain

1. Locate a drainpipe to which you can connect the washer drain.
2. Cut the pipe with a hacksaw and install a wye fitting or a sanitary tee, depending on the orientation of the pipe.
3. Run a length of 2-inch ABS pipe to the wall behind the washing machine.